Heavy Duty Sewage pump

Features:

WQ series Heavy Duty Submersible Sewage pump suitable for sewage systems with solids, waste water, removal of treated liquid waste and tank emptying and general dirty water duties.

Heavy Duty Submersible Sewage pump Specifications:

Max. water temperature: 40℃
Max. passage of solids: 70mm
Power up to 250kW
Max. Head: upto 65m
Max. Flow: upto 6500m3/h

Materials

Casing, impeller and elbow: cast iron
Shaft: stainless steel 2Cr13
Mechanical Seal: Double Mechanical Seal System Ceramic/Si.C/NBR (motor side)Si.C/ Hard Alloy
Fittings (on request): quick discharge connection

Technical Data

Insulation class F
Protection degree IP68
3~380/400/415V, 50Hz

Installation:

1. Before installation, must check whether the cable damaged, scratched, broken. If they are faulty, must consult dealer or technician qualified to replace it.

2.The earth wire(yellow and green wire) must be earthed reliably

3.Check whether the power supply is conformed to the stipulation of nameplate before installation. Power supply connected with the pump must assembled with electricity-leaking circuit breaker. The wave of voltage must controlled with+-10% of the rated.

4.Using iron thread or hoop to make the outlet and discharge pipe tight. Then tie a rope on the handle. Cable absolutely prohibited to be as sling to move the pump up and down.

5. Don’t touch and move the pump before cut-off the power to keep safe

6. Be sure that the cable is far from the heat, oil and sharp

7. The pump must install far from the human and livestock. Warning nameplate should placed at the installation location