End Suction Peripheral Pump

Transfer of clean water or non-aggressive liquid

Brass impeller

Special anti-rust treatment for pump body and support.

Maximum liquid temperature: +40

Maximum suction: +8 meter

Cast iron pump body

With thermal protector for all single phase motor

Anti-rust design with brass or SUS304 fitting to prevent the rust from jamming the impeller (Optional)

Dual-voltage are available for 110/230V, 60Hz (optional)

Electronic pressure switch are available to make automatic boosting system

impeller — Brass Impeller with radial peripheral blades

mechanical seal — Mechanical Seal: graphite to ceramic

Motor

Two-pole induction motor (n-2900 rpm)
Insulation Class B
Protection IP44/IP54
Single phase 230V or 110V, three phase 380V or 220V all available upon request.

Application of Our Vortex Pumps HPE

End Suction Peripheral Pump are suitable for handling clean water not containing abrasive particles and fluids, which are not chemically aggressive to the pump components. Those series pumps have features of reliable, economical, low maintenance and simple to use.

They are suitable for domestic applications and the automatic distribution of water from surge tanks, watering gardens and for boosting insufficient mains water pressure.

Warning of Peripheral Pumps

Before installing the pump, check the rotating parts of pump, make sure it could be turn freely as following:

Insert a screwdriver in the notch on motor shaft from the ventilation side, if there is a blockage, turn the screwdriver, tapping in gently with a hammer.
If the pumps not operated after long stopped, pls do as following:
1. Turn off the electric power
2. Turn the shaft in the back of motor with driver or something like that.
After the impeller could turn freely, operate the pumps as usual.